Mississippi bluff walkouts and downtown brick basements change routing time, not the order of work. Here is the clock we run once the core is already chosen and quoted.
Furnace Direct crews install heat- and energy-recovery ventilators in Hastings. Equipment is not sold over the counter — the quote includes the unit, labor, balance, and permit path.
Crew walks the path from truck to mechanical room, lays runners, and confirms the quoted core (HRV or ERV) against the work order before any cut.
Failed exchanger comes out, or we clear the agreed mount wall. Downtown brick basements get extra care around plaster and low headroom.
Intake and exhaust placed with separation from each other, dryers, and barbecue pads. Bluff lots often use the walkout wall; valley lots avoid snowdrift corners.
Supply and exhaust tied per the quote drawing. We keep runs short where Hastings joist bays allow and seal every joint.
Quick walk-through of progress, any discovery (crushed old duct, blocked chase), and confirmation you still want the quoted control location.
Wall control programmed, electrical landed, drain routed when the unit requires it. We label breakers clearly for the next service tech.
Measured supply versus exhaust. On tighter post-1990 Hastings plats we spend extra time here; on leakier older stock we still document the numbers.
Filter access, seasonal settings, what to expect the first cold week, and who to call. Trash and old unit leave with us unless you asked to keep a core photo.
Ready to put a day on the calendar? Core type must already be decided in the quote.
Ask for schedulingWalkout walls shorten outdoor runs. We watch freeze risk at hoods and keep intake away from downhill exhaust drift.
Party walls, alley setbacks, and limited joist depth favor compact equipment and careful chase use. Exterior aesthetics get reviewed in the quote when needed.
Expect a short learning curve on the wall control. January may still show brief glass film on the coldest nights while the house equalizes — call us if it worsens, not if it flickers once. Filters get a first check on our follow-up reminder; do not oil the core unless the label says so.
Signed quote with core type locked, access notes, and any association rules for exterior hoods. Photos of the mechanical bay and proposed hood walls are enough for most Hastings homes; a site visit is scheduled when downtown masonry or a failed prior install needs eyes on.
Routing time changes. Downtown masonry may need longer chase planning and association or alley-side hood placement. Bluff walkouts often give a clean below-grade wall for short runs. Core choice is separate and decided before we schedule.
Someone 18 or older should be there for arrival, the mid-day check, and the handoff. Errands in the middle are fine if we can reach you by phone and re-enter.
We isolate the zones we are tying into. Brief shutdowns happen when we cut into trunks or set controls; heat or cooling is usually back before we leave.
We measure clearances before install day. If the old footprint cannot fit a modern unit, we plan a new mount location in the quote so the day is not a surprise demo marathon.
We handle mechanical permitting for the install. Historic-downtown exterior hood questions get flagged at quote time if a commission review might apply.
No. Core type is locked in the quote so the right unit is on the truck. If your humidity story changed since the site visit, call before the schedule window — we reslot rather than guess on the driveway.
Tell us whether the core is already chosen or you still need the HRV vs ERV decision first. We schedule only after the quote is firm.
Cost-tier and comparison pages help lock the core; this page is only about the day itself.